When using a gasket:
Insert the sink flange through the sink gasket into sink opening. Do not rotate the sink flange, once it is seated. From underneath the sink, place the fibre gasket over the sink flange and screw the support ring on to the sink flange.
Note
There are arrows indicating the correct side to face upward.
Do not overtighten, the sink flange will not move when tightened securely.
Slip the mount ring over bottom end of the sink flange and hold in place while installing cushion mount flanged side down, so that the inside groove ‘G’ on cushion mount fits over the lip on the sink flange. When the cushion mount is properly seated, the mount ring can be pulled downward over the outside of cushion mount and will rotate freely.
Lift the disposer into position so the two projections ‘Y’ on top of the disposer hopper fit into the two slots ‘Z’ on the mount ring.
Turn the mount ring counter clockwise about one quarter inch so that the hopper projections engage. This will now support the disposer. Rotate the mount ring (and disposer) counter clockwise until the disposer waste outlet is in the desired position.
Connect the waste elbow to disposer and connect to trap.
Test the installation for water leaks and be sure all plumbing connections are tight. Make all connections in accordance with current regulations.
5
