7
A
C
B

Shelf holders

Your appliance is equipped with shelf retainers that make it possible to
secure the shelves during transportation. To remove them proceed as fol-
lows:
Move the shelf retainers in the direc-
tion of the arrow, raise the shelf from
the rear and push it forward until it
is freed and remove the retainers.
Remove transport safeguard
The appliance and the interior fittings are protected for transport.
• Pull off the adhesive tape on the left and right side of the door.
• Remove all adhesive tape and packing pieces from the interior of the
appliance.
26
What to do if ...

Correcting Malfunctions

If the appliance is not functioning correctly, please carry out the following
checks before contacting your local AEG Service Force Centre.
Warning!
Repairs should only be carried out by qualified service engineers. Repairs
carried out by inexperienced persons may cause injury or serious malfunc-
tioning of the appliance.
Symptom
Appliance does not work.
Possible Cause
Appliance is not switched
on.
Mains plug is not plugged
in or is loose.
Fuse has blown or is
defective
Socket is defective.
Mains malfunctions are to
be corrected by an electri-
cian.
Temperature is set too
cold.
Press “+“ (WARMER) but-
ton.
Remedy
Switch on the appliance.
Insert mains plug.
Check fuse, replace if
necessary.
Appliance cools too much.
The refrigerator and/or
freezer compartment tem-
perature is insufficient.
Temperature is not proper-
ly adjusted.
Please look in the “Starting
up and Temperatur regula-
tion” section.
Light bulb is defective.
Interior lighting does not
work.
Door was open for an
extended period.
A large quantity of warm
food was placed in the
appliance within the last
24 hours.
The appliance is near a
heat source.
Open the door only as long
as necessary.
Press TURBO COOLMATIC
button.
Please look in the “Installa-
tion location” section.
Please look in the “Changing
the light bulb” section.
The compressor does not
start immediately after
pressing the TURBO COOL-
MATIC button, or after
changing the temperature
setting.
This is normal, no error has
occurred.
The compressor starts after
a period of time.