9
SOMETHING NOT WORKING

Symptom

No power to the appliance
The light does not come on
The temperature in the fridge
The compressor runs continously
Noise
Water under the salad crispers

Solution

Check there is power at the socket.
Check there is not a power cut by checking the
household lights.
Check the fuse has not blown.
Ensure that the bulb is correctly fitted.
Replace the bulb if it has blown.
Check the door light switch is not jammed.
Check the thermostat control knob in the fridge is
turned to the correct setting relative to ambient
conditions.
Check the ambient temperature is within the
appliance’s operating limits, please refer to the
installation section in this instruction book.
Relocate the appliance if necessary.
Adjust the thermostat control knob to give correct
temperature control. See “Setting the temperature”.
Check that the door is closed.
Large quantities of food have recently been placed in
the cabinet and/or door is frequently opened.
Check that air ventilation is not obstructed.
Refer to normal operating sounds.
Check the drain hole is not blocked. (see
Maintenance and Cleaning).
If the appliance is not working correctly, please carry out the following checks before contacting your local
Zanussi Service Force Centre
If after the above checks your appliance still does not operate correctly, contact your local Zanussi Service
Force Centre.
Please note that it will be necessary to provide proof of purchase for any in-guarantee service calls.
In-guarantee customers should ensure that the above checks have been made, as the engineer will
make a charge if the fault is not a mechanical or electrical breakdown.
12
TECHNICAL SPECIFICATIONS
POWER SUPPLY VOLTAGE AND FREQUENCY 220-240 V / 50 Hz
TOTAL POWER ABSORBED 80 W
AVERAGE DAILY UNITS ELECTRICITY * 0.53 kWh

GROSS CAPACITY

Fridge 230 l

NET CAPACITY

Fridge 228 l
* This figure is based on standard test results in accordance with European Standard EN 153.
Actual consumption will depend on how the appliance is used and where it is located.