Ofrecido por www.electromanuales.com
Unpacking
The transport safeguard must be removed before putting the appliance into operation.
Important !
You are advised to keep all the packaging for
●After removing all the packaging, with assistance carefully lay machine on it’s back to remove the polystyrene base from the bottom.
●Remove the power supply cable and the draining hose from the hose holders on the rear of the appliance.
HEC0008 | HEC0001 |
●With a suitable spanner unscrew and remove the central rear bolt A. Slide out the relevant plastic spacer.
●Unscrew and remove the two large rear bolts B and the six smaller bolts C.
●Fill the smaller upper hole and the two large ones with the corresponding plastic plug caps supplied in the bag containing the instruction booklet.
HEC0005 | HEC0009 |
Important!
All the different plug caps are supplied with the appliance in the plastic bag containing the instruction booklet.
●Connect the water inlet hose as described under the paragraph “Water inlet”.
Positioning
Install the machine on a flat hard floor.
Make sure that air circulation around the machine is not impeded by carpets, rugs etc. Check that the machine does not touch the wall or other kitchen units.
A
HEC0002
|
|
| C |
| C | D | B |
HEC0003 | B |
|
Never place cardboard, wood or similar materials under the machine to compensate for any unevenness in the floor.
Your new washing machine has been designed to be permanently plumbed in to your home’s water supply and drainage system. However, if this is not possible, it may be connected to a suitable existing tap with the drain hose discharging into a sink.
The appliance has an inlet hose, with female 3/4” BSP thread connector. If this connection is not compatible with
●Remove the bracket D and tighten up the six smaller bolts C.
●Open the porthole and remove the polystyrene block fitted with the adhesive tape on the door seal.
the plumbing of the existing installation, a variety of connectors are available from good hardware stores and plumbers merchants to suit most domestic plumbing. Any alteration to your existing plumbing must be carried out by a competent person, or qualified plumber.
HEC0011 |
HEC0010 |
Installation on a Suspended Floor
Suspended wooden floors are particularly susceptible to vibration. To help prevent vibration we recommend you place a waterproof wood panel, at least 15 mm thick under the appliance, secured to at least 2 floor beams with screws. If possible install the appliance in one of the corners of the room, where the floor is more stable.
24
