INSTALLATION INSTRUCTIONS
OPERATING INSTRUCTION
READ AND SAVE THESE INSTRUCTIONS
GENERAL
•Carefully read the following important information regarding installation safety and main- tenance. Keep this information booklet accessible for further consultations.
The appliance has been designed for use in the ducting version (air exhaust to the outside
– Fig.1).
INSTALLATION INSTRUCTIONS
• Power Supply Connection
For connection to the power supply refer to the follows fig.8 :
BLACK | = L line |
WHITE | = N neutral |
GREEN /YELLOW | = G ground |
A
The appliance must be installed at a minimum height of 26 inches (66 cm) from an electric cooker stove, or 30 inches (76 cm) from gas or combined cooker stoves. If a connection ductwork composed of two parts is used, the upper part must be placed outside the lower part.Do not connect the range hood exhaust duct air to the same duct air used to exhaust hot air or fumes from other appliances other than electrical. Before proceeding with the assembly operations, remove the
WARNING
Before installing the appliance fix the electrical box as indicated in fig.1
-Remove the central screw fig.1A.
-Lift the electrical plant box fig. 1B.
-Remove the 3 fixed screws fig.1C.
-Position the electrical box so it is in line with the holes of the previously removed screws fig.1D and tighten.
-Pay attention that the tear tape of the electrical box is inside the slot
and then tighten screw fig.1E.
• FIXINGTO THE WALL
Drill the holes A respecting the distances indicated (Fig.3). Fix the appliance to the
wall and align it in horizontal position to the wall units. When the appliance has been adjusted, definitely fix the hood using the screws A (Fig.5). For the various installations use screws and screw anchors suited to the type of wall (e.g. reinforced concrete, plaster-
- 8 -
