B/W, Color and Low Lux Color Cameras
for the EL25 telephone entry/access control system
Model EL25BWCAMKT
Model EL25CCAMKT
Model EL25DVRCAMKT
Caution!
A static discharge can
DAMAGE circuit boards.
LED Board
+
1Disconnect power to the unit!
2Unlock and open the unit.
3Unplug the wire harness from LED board, remove and discard call button board. (3 screws) Keep “O” ring from old board and place on new board.
LED
Board
Wire
Harness
Camera Module
Replaces the LED Board.
4Replace black plastic lens with the clear 5 Install the camera module (3 screws). Reconnect the
lens. Keep rubber “O” ring in place. | LED board wire harness to the camera module. |
7Plug the other end of the coaxial cable into a monitor or home entertainment system. Reconnect the power to the EL25 and the camera picture will appear.
NOTE: If the EL25 is connected to a home entertainment system, the home entertainment system must be switched to video input.
6Feed coaxial cable (not provided) through the conduit hole in the back mounting plate of the EL25. Carefully connect a BNC coaxial connector to the back of the camera module. Close and lock the unit.
Vertically Mounted EL25s ONLY:
The camera lens board must be repositioned 90 degrees counterclockwise before the above steps can be performed.
Note: Carefully remove the 2 mounting screws in a secure flat area to avoid losing the parts!
H2 100A UD | H2 100A UD | H2 100A UD | H2 100A UD |
Repositioned camera lens board (Portrait) ready for installation in a vertically mounted EL25.
2