Elite B/W, EL20008WCAMKT, EL2000CCAMKT, EL2000DVRCAMKT manual

B/W, Color and Low Lux Color Cameras

for the EL2000 telephone entry/access control system

Model EL2000BWCAMKT

Model EL2000CCAMKT

Model EL2000DVRCAMKT

	Caution!
	A static discharge can
LED Board	DAMAGE circuit boards.

Camera Module

Replaces the LED Board.

1Disconnect power to the unit!

2Unlock and open the unit.

3Unplug the wire harness from LED board, remove and discard LED board. (3 screws) Keep “O” ring from old board and place on new board.

LED

Board

Wire

Harness

4Replace black plastic lens with the clear 5 Install the camera module (3 screws). Reconnect the

lens. Keep rubber “O” ring in place. LED board wire harness to the camera module.

7Plug the other end of the coaxial cable into a monitor or home entertainment system. Reconnect the power to the EL2000 and the camera picture will appear.

NOTE: If the EL2000 is connected to a home entertainment system, the home entertainment system must be switched to video input.

6Feed coaxial cable (not provided) through the conduit hole in the back mounting plate of the EL2000. Carefully connect a BNC coaxial connector to the back of the camera module. Close and lock the unit.