Elk specifications Instructions ELK-45

Instructions ELK-45

1.Mount the U shaped bracket to the wall.

2.Insert one of the two short bolts into each side of the U shaped bracket with the threads protruding out.

3.Align the heads of the bolts with the slotted openings on each side of the siren housing.

4.Slide the siren onto the bolt heads. Install a washer and nut on each bolt and tighten.

5.Connect Black wire to Neg (-) of alarm output.

6.Connect Red wire to Pos (+) of alarm output.

NOTE: Siren is factory set for maximum loudness with a current draw of about 1.2 Amps. To lower the current draw and volume, remove the four screws and cover from the back. Follow the Red speaker wire to where it solders to the circuit board. Cut this Red wire approx. 3" back from the board. Splice the Red wire from the speaker to the unused Yellow wire on the circuit board using the enclosed wire nut.

The ELK-45 is designed for Single Output Alarm Controls that use a STEADY Output for BURG or a PULSING Output for FIRE. For an Alarm Control panel that has separate BURG and FIRE alarm outputs connect the Red wire to each output, then program one output for Steady(Burg) and the other for Pulsing(Fire). Connect the Black wire to Neg.