Elmo SUV-CAM manual 139

							Troubleshooting (Continued)
■Played video
		Symptom				Cause	Remedy
	The	video	cannot		be	Is the SD memory card loaded?	Load the SD memory card saved with the recorded data.
						Is there any playable data on the SD memory	Video record /audio record the data in the recorder, and then play
	played.
						card?	the data. (ÎP108)
	The video in play is rough.					The resolution and the video quality are set too	Raise the resolution and video quality settings higher, and then
						low.	record the data. (ÎP123, 124)
	The	video	in	play	is	When video is short in a dark place, noise may	Record the data in a bright place.
	accompanied by noise.					be generated to maintain the brightness.
	Vertical stripe			pattern	is	When intensive light like spot light is irradiated to	This is not a failure.
						a part of the screen, vertical stripe pattern or the
	seen.					like may be seen.
	The video is too bright or					Is the exposure “Camera Brightness” setting	Change the exposure set value in adjustment to the desired
						proper?	brightness. (ÎP110, 111)
	too dark.
						Is the record mode set properly?	When video only is recorded, audio is not recorded.
						Is “Record setting” set to “Video only (No	Set “Record setting” to “Video recording + Audio recording.”
						audio)”?	(ÎP123, 124)
						The Audio side of the earphone or AV cable is	Make proper connection. (ÎP122)
						not connected with the Audio Input side of the
	No audio is heard.					TV or the like.
						The audio volume of the recorder is low.	Increase the audio volume. (ÎP114)
						When the recorder is connected to the TV or the	Adjust the volume of the TV or the like.
						like, the volume of the TV or the like is smaller
						than that should be.

139