Elta 3653 manual Listening to the Radio, Headphones, Specification

02-3653-GB 7/14/06 4:29 PM Page 7

Battery Operation

Open the battery compartment (6) of the Radio and insert four UM-2 (R14/Baby) or equivalent batteries following the polarity diagram shown inside the battery compartment.

If the radio does not function or the sound is distorted, the batteries may be exhausted and need to be replaced with new ones. If the unit is not to be used for sometimes or is being run exclusively on AC Power, remove batteries to avoid leakage. Plugging in the Mains Lead automatically cuts off the battery connection. To return to battery operation, remove the mains lead.

Batteries should be removed from the compartment if the unit is not to be used for sometime. Discharged batteries should be removed from the unit to avoid leakage.

Listening to the Radio

Operation

Turn the Volume Control (3) to switch the radio on.

Select the desired frequency band with the Band Selector (2).

Turn the tuning Control (4) until the desired radio station is found.

Adjust the Volume Control (3) to the desired level.

To turn off the radio, turn the Volume Control (3) until it clicks.

Antenna

For FM reception there is a built-in extendable FM Antenna (5) at the rear of the unit. Extend the aerial and move it around to obtain the best reception.

For AM reception the signals are picked up through the built-in ferrite antenna. You may have to rotate the unit to obtain the best reception.

Headphones

Headphones should have a 3.5mm diameter mono plug and an impedance of 8 – 32 Ohms. When headphones are connected, the speakers are automatically disconnected.

Specification

Power supply
AC:	230V – 50 Hz

Battery power: 4 x UM-2/R14/Baby batteries (or equivalent)

Radio Frequency Coverage

FM:	87.5 – 108 MHz
AM:	525 – 1615 kHz

General

Headphones: 3.5mm mono jack plug 8 – 32 Ohms

SPECIFICATION ARE SUBJECT TO CHANGE WITHOUT NOTICE

￿ 7.