GB
SAFETY INSTRUCTIONS
•The safety guard (3) must be in faultless condition at any time.
•Do not put any objects into the safety guard or the air inlet openings
(4). The safety guard and the air inlet openings may not be covered during operation.
•Small children, children and older persons should not be exposed to the cold stream of air for continuous time.
•Do not use the device in very hot or damp surroundings (e.g. bathroom or toilet).
•Unplug the mains plug from the electrical outlet before cleaning or disassembling.
•Never operate the device without pedestal or in a lying position.
•Keep loose objects like plants, curtains, etc. away from the device.
•Connect the device to power supply only after it is completely assembled.
INTENDED USE
•This device is only meant for private domestic use and has to be used as a fan to circulate the room air. The device is not intended for commercial or industrial use.
PRIOR TO FIRST USE
•Remove all packaging materials.
•Clean the appliance, as described in Cleaning and Care. Dry all parts carefully before using them.
ASSEMBLY
•Put the tower fan on a flat surface (e.g. a table) so that the base part (11) points to you. For the following assembly steps see Fig. 2.
•Put the back pedestal part (12) on the 2 cam levers in the base part; the power cord (6) must be placed in the middle of the base part.
•Put the power cord into the
Fasten the power cord with the cable support (14) and the Phillips screws (15).
•Put the front pedestal part (17) on the base part. Put the front pedestal part on the cable guide in the base part as well as the cam levers at the back base part.
•Fasten the front pedestal part with the Phillips screws (18) in the openings at the front pedestal part (16.)
•Now set the tower fan vertically. It is ready for use.
9
GB
11.Base part
12.Back pedestal part
13.Cable guide
14.Cable support
15.Phillips screw (cable support)
16.Opening for pedestal fastening
17.Front pedestal part
18.Phillips screw (pedestal fastening)
11 | 12 | 13 | 14 | 15 | 16 | 17 | 18 |
Pic. 2
OPERATION
•Connect the mains plugs (6) with a proper electrical outlet.
•Open the cover (1). Push the level buttons 1 / 2 / 3 (9) to switch on the device and select the desired level.
1 = low speed
2 = middle speed
3 = high speed
•Push the off button (8) to switch off the device.
Oscillation
•Push the oscillation button (7) for swinging from left to right. To keep the air stream at certain position push the oscillation button again at the desired position.
Timer
•The fan is equipped with an automatic timer which automatically turns the device off after the set time is over.
•One of the level buttons 1 / 2 / 3 must be pushed in the timer mode.
•Adjust the desired time in the range of 0 - 120 minutes by turning the timer switch (10) clockwise. The device switches off after the set time is over.
•Put the timer switch on ON to switch on the device again.
10
