Emerson CF152WW00, CF144WW00, CF152BS00, CF152ORB00 Setting Operating Frequency Remote Control

BP7407 44" & 52" Curva Sky 1/11/10 9:54 PM Page 11

Setting Operating

Frequency of

Remote Control

Your remote control has code switches which must be set in one of 32 possible code combinations (Figure 16). The five levers (numbered 1, 2, 3, 4, and 5) on the switches are factory-set in the ON (up) position. Change the switch settings as follows (Figure 18):

1. Slide the five switch levers in the remote control to your choice of ON (up) or down positions. Use a ball-point pen or small screwdriver and slide the levers firmly up or down.

2. When power is restored, push and hold the fan OFF button ( ) for 3 to 5 seconds to set the code in the receiver.

3. If airflow is desired in the opposite
direction, press the ( ) button on the	Figure 18
remote control. The fan must be
operating at any speed for the reverse
button to function. The blades will turn
in the opposite direction and reverse
the airflow.

4. To set the desired fan speed, press the () button to decrease the speed and the ( ) to increase the speed. The LED display will light up to indicate the new speed selected.

5. To turn the downlight on, press and release the ( ) button. The light will turn on at the light intensity previously selected.

6. To vary the intensity of the light, hold the ( ) button down until the desired light intensity is reached, then release the button.

7. The sixth switch marked ON and I is for dimming control of lights: Set switch to ON to allow for dimming of the lights. Set switch to I for no dimming of the lights such as for fluorescent bulbs.

11 UL Model No.: CF144 & CF152