Emerson CF705HTW04, CF705PB04, CF705AGW04, CF705ORB04 How to Put Your Ceiling Fan Together

How to Put Your Ceiling Fan Together

1.Pass the 42” motor leads through the opening in the ceiling cover. Be sure the cover is oriented correctly (Figure 1).

2.Separate, untwist and unkink the three motor leads. Route the motor leads through the hanger ball/downrod assembly.

3.Loosen the two screws in the motor coupling. Align the clevis pin holes in the downrod with the holes in the motor coupling. Install the clevis pin and secure with the hairpin clip (Figure 1). The clevis pin must go through the holes in the motor coupling and the holes in the downrod. Be sure to push the straight leg of the hairpin clip through the hole near the end of the clevis pin until the curved portion of the hairpin clip snaps around the clevis pin. The hairpin clip must be properly installed to prevent the clevis pin from working loose. Pull on the hanger ball to make sure the clevis pin is properly installed.

!WARNING

It is critical that the clevis pin in the motor coupling is properly installed and the setscrews securely tightened. Failure to verify that the pin and setscrews are properly installed could result in the fan falling.

MOTOR

M5 x 10COUPLING

SETSCREWS

CLEVIS PIN	HAIRPIN
	CLIP

HANGER BALL/

DOWNROD ASSEMBLY

CEILING

COVER

CLEVIS	CLEVIS
PIN	PIN
M5 x 10	HAIRPIN
SETSCREWS
	CLIP
	MOTOR COUPLING

Figure 1

4.While pulling up on the hanger ball, securely tighten the two setscrews in the motor coupling

(Figure 1).

NOTE: The setscrew must be properly installed as described above, or fan wobble could result.

5.The fan comes with blue, black and white leads that are 42-inches long. Before installing the fan, measure up approximately 6 to 9-inches above top of hanger ball/downrod assembly. Cut off excess leads and strip back insulation 1/2-inch from end of leads.

6.Mount the blade flanges to fan blades using three M5 x 6 washer head blade screws per blade (Figure 2).

!WARNING

To reduce the risk of personal injury, do not bend the blade flange when installing the blade flanges, balancing the blades or cleaning the fan. Do not insert foreign objects in between rotating fan blades.

M5 x 6 WASHER HEAD BLADE

SCREW (3)

	FAN BLADE
Figure 2	BLADE FLANGE

NOTE: Take care not to scratch fan housing when installing blades.

NOTE: Remove and discard the four shipping spacers and screws from the motor hub.

7.Turn the fan assembly upside down in preparation for mounting the fan blade assemblies.

8.Rotate the motor hub until the flange screw hole is next to the cutout in the switch housing plate. Attach the blade assembly to the motor hub using the two M6 x 14 flange screws preassembled in flange (Figure 3). Make sure all screws are tight- ened. Repeat this procedure for the other four blade assemblies.

SWITCH HOUSING	BLADE FLANGE
PLATE

MOTOR HUB	PREASSEMBLED M6 x 14
	FLANGE SCREWS (2)

Figure 3

9.The blade flanges have an interlocking feature that must be fully engaged before tightening the screws. Make sure all the flanges are properly engaged and then tighten the flange screws. If one of the flanges does not seat properly on the motor hub, loosen the adjacent flange screws, re- engage and reseat the flanges, then tighten the screws again.

10.Engage the connector of the switch housing assembly with the motor connector (Figure 4). The two connectors are keyed and color-coded and must be mated correctly (color-to-color) before they can be engaged. Make sure the con- nector latch closes properly.

4 U.L. Model No.: CF705