Emerson CF711WW01, CF710AB01, CF710BS01 Installing Hanger Bracket, Hanging The Ceiling Fan

Installing The

Hanger Bracket

! WARNING

The fan must be hung with at least 7' of clearance from floor to blades (Figure 4).

7'

MIN.

Figure 4

FLOOR

! WARNING

The outlet box and joist must be securely mounted and capable of supporting at least 50 lbs. Use only a U.L. outlet box listed as “Acceptable for Fan Support”.

1.Unscrew (but do not remove) the two mounting screws in the outlet box (Figure 5). Position the hanger bracket on the outlet box so that the T-slots in the hanger bracket are aligned with the outlet box screws.

	OUTLET BOX
	LOOSEN TWO
T-SLOT	SCREWS (SUPPLIED
	WITH OUTLET BOX)

SLIDE THE HANGER

BRACKET ONTO

THE OUTLET BOX

SCREWS, THROUGH

THE T-SLOT

HANGER

BRACKET

Figure 5

! WARNING

To reduce the risk of fire, electrical shock, or personal injury, mount fan to outlet box marked “Acceptable for Fan Support”, and use screws supplied with outlet box. Most outlet boxes commonly used for support of light fixtures are not acceptable for fan support and may need to be replaced. Consult a qualified electrician if in doubt.

NOTE: The hanger bracket must be mounted flush with the ceiling in order for the ceiling cover to install properly. If necessary, use leveling washers (not supplied) between the outlet box and the hanger bracket.

2.Slide the hanger bracket onto the outlet box screws. Center the bracket over the outlet box and then securely tighten the screws (Figure 6).

! WARNING

Hanger bracket must seat firmly against outlet box. If the outlet box is recessed, use leveling washers between the hanger bracket and the outlet box until the bracket is flush with the ceiling. If bracket and/or outlet box are not securely attached, the fan could wobble or fall.

	SECURELY
	TIGHTEN
HOOK	SCREWS
	HANGER BRACKET

Figure 6

Hanging The Ceiling Fan

(Standard Method Using

Hanger Ball/Downrod)

1.Carefully lift the fan assembly and seat the hanger ball in the hanger bracket (Figure 7). The tab on the hanger bracket must seat in the groove in the hanger ball.

! WARNING

Failure to seat tab in groove could cause damage to electrical wires and possible shock or fire hazard.

! WARNING

To avoid fire or shock, do not pinch wires between the hanger ball/downrod assembly and hanger bracket.

5 U.L. Model No.: 42-ANT/52-ANT