Emerson CF805SWW 00, CF805SBS 00 Unpacking Instructions, Tools Needed for Assembly, Materials

This Manual Is Designed to Make it as Easy as Possible for You to Assemble, Install, Operate and Maintain Your Ceiling Fan

Tools Needed for Assembly

One Phillips head screwdriver

One 1/4" blade screwdriver

One stepladder

One wire stripper

Three wire connectors (supplied)

Materials

Wiring electrical box and box connectors must be of type required by local code. The minimum wire would be a 3-conductor (2-wire with ground) of size shown at right.

Installed Wire Length	Wire Size A.W.G.
Up to 50 ft.	14
50 - 100 ft.	12

!WARNING

Before assembling your ceiling fan, refer to section on proper method of wiring your fan (page 5). If you feel you do not have enough wiring knowledge or experience, have your fan installed by a licensed electrician.

Unpacking Instructions

For your convenience, check-off boxes are provide next to each step. As each step is completed, place a check mark in the box. This will insure that all steps have been completed and will be helpful in finding your place should you be interrupted.

!WARNING

Do not install or use fan if any part is damaged or missing. Call Toll-Free:

1-800-654-3545

2. Remove the fan assembly from the protective plastic bag. Place the fan assembly into the upper foam pad with the lead wires up.

!WARNING

This product is designed to use only those parts supplied with this product and/or any accessories designated specifically for use with this product by Emerson Company. Substitution of parts or accessories not designated for use with this product by Emerson Company could result in personal injury or property damage.

1.Check to see that you have received the following parts:

NOTE: If you are uncertain of part description, refer to exploded view illustration.

a.Fan housing

b.Mounting plate

c.Fan motor assembly

d.Five fan blades

e.Five blade flanges

f.One loose parts bag containing:

1.Sixteen 3/16-24 x 9/32" phillips washer head screws.

2.One wood ball with chain.

3.Three wire connectors.

4.Four 3/16-24 x 5/8" housing screws.

5.Four 1/4" hex locknuts.

6.Eleven 1/4-20 x 1/2" phillips head screws.

NOTE: Place the parts from the loose parts bag in a small container to keep them from being lost. If any parts are missing, contact your local retailer or catalog outlet for replacement before proceeding.

3

LOWER

FOAM PAD

CARTON

FAN

BLADES

UPPER

FOAM PAD

MOUNTING PLATE

FAN HOUSING

BLADE FLANGES

FAN MOTOR ASSEMBLY