RADIO AND BUZZER OPERATION
You may also set one alarm for wake to radio and the other for wake to buzzer. Just set the ALARM 1 and ALARM 2 selector switches to the desired positions.
SNOOZE ALARM
After the radio or buzzer alarm sounds in the morning you may press the SNOOZE bar for a few more minutes sleep. The alarm will stop for approximately 9 minutes and then turn on again. You may repeat the Snooze operation up to seven times if desired, but after the seventh time the alarm will not turn on again.
SLEEP TO MUSIC TIMER
You can program the sleep timer to play the radio for up to 90 minutes and then shut off automatically.
1.) Press the SLEEP button. The display will briefly show “10” and the radio will begin to play. After 10 minutes the radio will shut off automatically. Each time you press the SLEEP button the sleep timer will start at 10 minutes. This is the sleep timer default setting.
2.) To increase or decrease the amount of time that the radio will play before shutting off, hold the SLEEP button and press either the SET + or SET – button to change the display to the desired sleep time, up to a maximum of 90 minutes or a minimum of 2 minutes.
NOTE: When you change the sleep timer from the 10 minute default setting to a different setting, the new setting becomes the default setting. Whenever you activate the sleep timer it will begin with your new default setting and count down to zero from that point.
3.) To cancel the sleep timer before it counts down to “00” and shut the radio ‘Off’ immediately, press the SNOOZE bar.
IMPORTANT:
Remember that the station and volume settings you choose for the Sleep To Music operation are the same settings you will hear if you set the alarm for wake to radio the following morning.
DIMMER CONTROL
The DIMMER switch was set to the ‘HIGH’position at our factory. If you find the clock display is too bright in a darkened room, set the DIMMER switch to the ‘LOW’position.
12
CKS2288_ib_092302.p6512
23/9/2002, 11:53
