Introduction• About this Guide
• System Compatibility
1
This guide describes how to install and configure your new
Smart Energy thermostat.
This product replaces most thermostats, including those
that work with:
• Standard Heat and Cool Systems
• Two-Stage Heat and Two-Stage Cool Systems
• Air Source Heat Pump (with Aux. or Emergency Heat)
• Ground Source Heat Pump (with Aux. or Emergency Heat)
• Air or Ground Source Heat Pump (No Aux. or Emergency Heat)
• Standard Heat Only Systems
• Standard Central Air Conditioning
• Gas or Oil Heat
• Electric Furnace
• Hydronic (Hot Water) Zone Heat – 2 Wire zone valves
Failure to read and follow all instructions carefully before installing or
operating this control could cause personal injury and/or property
damage.
To prevent electrical shock and/or equipment damage, disconnect
electric power to system at main fuse or circuit breaker box until
installation is complete.
Do not use on circuits exceeding specified voltage. Higher voltage will
damage control and could cause shock or fire hazard.
CAUTION