Emerson EM-252 owner manual FCC and telephone company information, Drive safe, Safety information

®

Wireless Headset

Model EM-252

FCC and telephone company information

FCC Part 15

This equipment has been tested and found to comply with the requirements for a Class B digital device under Part 15 of the Federal Communications Commission (FCC) rules. These requirements are intended to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

●Re-orient or relocate the receiving antenna.

●Increase the separation between the equipment and receiver.

●Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

consult the dealer or an experienced radio/TV technician for help.

Changes or modifications to this equipment not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Drive safe

Driving while talking on your mobile phone is dangerous, and illegal in many states.

Although this device enables drivers to conduct handsfree conversations, it is still dangerous to drive and use a mobile phone at the same time.

We recommend pulling over before making or answering calls, especially during adverse driving conditions. Please use your mobile phone, and our product responsibly while driving!

Safety information

●Check local laws regarding use of a mobile handset and wireless headset while driving. If you use the Bluetooth Headset while driving, ensure your attention and focus remains on your driving.

●Observe all signs in the designated areas where some electronic devices or RF radio products are required to be switched off. These could include airplanes, hospitals, blasting areas, and potentially explosive atmospheres.

Location of controls

Power button

Power ON/OFF

LED indicator light Answer/Reject incoming calls

Dial last number

Pair

Mini USB port

Volume down Volume down/

microphone mute

Volume up Volume up/ conversation switch/ microphone mute

Ear hook

Microphone

Speaker

IN THE BOX:

Bluetooth	USB Cable	Car Charger	Travel Charger	Owner’s
Headset				Manual

1Charging the Bluetooth headset

1.Connect the USB cable to the charging socket on the handset.

2.Connect the USB cable to:

●AC Charger, and plug into a wall (A/C) outlet.

●Computer’s USB port.

●Car Charger.

3.The RED LED indicator light turns on.

4.The RED LED indicator light shuts off when the headset is fully charged. (approximately 2 hours)

NOTE: Make sure you charge your headset for two hours before using it for the first time.

2Pairing the headset with a Bluetooth enabled phone

1.Keep your Bluetooth Headset and mobile phone within 3 feet of each other during pairing.

2.Make sure the Bluetooth Headset is turned off.

3.Press and hold the [POWER] button until the RED and BLUE lights flash alternately.

EM252

4.Set the phone to search for bluetooth devices.

5.When the phone finds the headset, confirm by selecting EM252 from the list.

EM252 EM252 added

1234