Emerson ES50 owner manual Setting The Clock

SETTING THE CLOCK

1.) Switch the unit to Standby mode by pressing the POWER button.

2.) Press and hold the MEMORY/CLOCK-ADJ button. “ 24 H ” (24 Hour format) will

flash in the display. Press the or button to select “ 12 H ” (12 Hour format).

3.) Press the MEMORY/CLOCK-ADJ button. The hour digit will flash.

Press the or buttons to set the correct hour. Be sure to set correctly for AM or PM.

4.) Press the MEMORY/CLOCK-ADJ button again. The Hour is now set and the Minute digits start to flash in the display.

5.) Press the or buttons to set the correct minute.

6.) Press the MEMORY/CLOCK-ADJ button again. The Minutes are now set and the clock will start to run.

NOTE:

•Clock time is only retained while the unit is plugged into the AC outlet. In the event of a power failure the clock will need to be reset when the power supply resumes.

•Clock time is only shown when unit is in Standby mode.

10

ES50_ib071403.p65 10

14/7/2003, 11:40