Emerson HD7096A, HD7099A owner manual Operating Instructions, Normal Playback

OPERATING INSTRUCTIONS

NORMAL PLAYBACK

NOTE: Although this CD player can read CD-R and CD-RW discs, in addition to normal CDs, the playability of CD-R and CD-RW discs may be effected by the type of software that was used to create the discs, as well as the quality and condition of the blank media you are using. 100% playability cannot be guaranteed. This is not an indication of a problem with the player.

To PHONES Jack

1.) Connect the headphones to the PHONES jack. Set the VOLUME control to a low level before you begin playback and then adjust the volume to a comfortable level after playback begins.

2.) Slide the CD Door OPEN switch to the right to release the lock and open the CD Door.

3.) Place your disc on the center spindle with the printed label side facing up. Press down gently near the center hole to make sure the disc is properly seated on the spindle.

4.) Close the door completely until it locks shut.

5.) Press the PLAY/PAUSE button to begin playback on Track 1. Joggable indicator flashes and the playing time shows in the display.

6.) Adjust the VOLUME and DBBS (Bass Boost) controls as desired.

7.) When all tracks have been played the player stops and the display shows the total tracks and playing time on the disc. After approximately 1 minute the power shuts off and the display goes blank.

To stop playback before the disc ends press the STOP button at any time. Press the STOP button again to shut the power off immediately.

8.) Slide the CD Door OPEN switch to the right to open the door and remove your disc. Close the CD Door and return your disc to its protective storage case.

	PLAY/PAUSE
ON	DBBS OFF
VOLUME

STOP

OPEN

7

HD7096A_7099A_071403.p657

14/7/2003, 10:34