Parameters set up or changing to submenus:

¨Select the line of variables, any menu line or the function line with the ↓ -key or the − -key.

¨Select the variable, start the function or change to the submenu with the 8 -key or the → -key.

¨Select any digit with the ← -key or the → -key and adjust a new value with the − -key or the ↓ -key

resp. select the whole parameter with the − -key or the ↓ -key.

¨Confirm the new value with the 8 -key or

cancel and go back to the last value with the F2 key.

Line of variables "Alarm delay":

The alarm message of any enabled parameter will start after the time in this line is over. Options: 0, 0.1, ... , 30.0 s.

Function line "Acknowledge alarms !":

Starting this function will delete a running alarm message. You should do this after the signal is back in the allowed range to reset the alarm message for new events.

Note:

Via the F2 key you will reach the menu "Analyzer Channel Status". In that menu and its corresponding submenus you will find the status report of the current channel for

¨Failures

¨Maintenance requests

¨Function controls

¨Measurements/Alarms

¨Events

¨Hours of operation

and the operational settings of the current channel like

¨range settings and

¨response time (t90-time).

The menu "Analyzer Channel Status" and its submenus are displayed detailed in section 4.1.

5 - 22

NGA 2000

90003482(2) [NGA-e (MLT-Software 3.2.X)] 07/98