7 Display Controls

The menu "Front Panel Control"

Set up the number of digits:

¨Select one of the two lines of variables with the ↓ -key or the − -key.

¨Select the number with the 8 -key or the → -key.

¨Select the digit with the − -key or the ↓ -key. Options: Maximum total number of digits: 3, 4, 5, 6

Digits after the decimal point:

0, 1, 2, 3.

¨Confirm the new value with the 8 -key or

cancel and go back to the last value with the F2 key.

Example:

¨Measured number: 1.2345

¨Select 3 for total number of digits and 2 for digits after decimal point.

¨The screen will display: 1.23

The menu "Auxiliary Lines"

Set up parameters:

¨Select any line of variables or any menu line with the ↓ -key or the − -key.

¨Select the variable or change to the submenu with the 8 -key or the → -key.

¨Select "Enabled" or "Disabled" with the − -key or the ↓ -key to enable or disable the corresponding auxiliary line in the single component display of the current channel.

¨Confirm your setup with the 8 -key or

cancel and go back to the last one with the F2 key.

Choose the source module for the auxiliary lines:

Via the corresponding menu line you can change to a submenu, where you can select the source module for the first/second/third or fourth line of the single component display. The tags of all modules combined with the platform or MLT analyzer will be available:

90003482(2) [NGA-e (MLT-Software 3.2.X)] 07/98

NGA 2000

7 - 3