II) V24/RS232/485 Interface - Single Analyzers and Systems

ETOL – Write command "Stability tolerances"

With this write command the analyzers in a system, the single analyzer or the front-end computer will get the required tolerances for functions running stability controlled. The tolerance will be specified in percent of the end of range value. The tolerance can be adjusted for each range separately. No tolerance check will be done, if the tolerance value will be set to T = 100%.

Write command

ETOL Kn M1 Tn1 [...Mm Tnm]

Tolerance channel n, range m in percent of the end of range value;

tolerance deviation = 2 * tolerance (optional)

Tolerance channel n, range 1

Range 1

Addressed channel n

Code

Response

ETOL 0

Error status

Code

90003752(1) [AK-Commands] 10/98

AK

2 - 101