II) V24/RS232/485 Interface - Single Analyzers and Systems
4. Description of all Read Commands
AAEG – Read command "Deviation to spangas"
To this read command the analyzers in a system or the single analyzer will send to the TBCC the following data for the called channel (device):
∗The measured and stored signal of the last spangas measurement.
∗The deviation from the setpoint value of the linearized curve in ppm and percent,
referred to the end of range value.
Spangas measurement: Signal after the end of the functions "Automatic calibration" or "Spangas", stability controlled or time controlled depending on the setup in "EFDA".
Read command
AAEG K0
AAEG Kn
Read of the whole system unit
Code
Response
AAEG 0 M1 XXX YYY ZZ ... Mn XXX YYY ZZ
Deviation [%]
Deviation [ppm]
Signal [ppm]
Range n
Deviation [%]
Deviation [ppm]
Signal [ppm]
Range 1
Error status
Code
The values will get the same format for the read of single channels.
90003752(1) | AK | 2 - 39 |