OPERATING INSTRUCTIONS
LISTENING TO THE RADIO
1 |
|
2 | 1 |
2 |
3 |
Set the VOLUME control ❶ to a low setting. Press the POWER button ❷ to turn the unit on.
Press the FUNCTION button until the tuner (“AM” or “FM” and a frequency) appears in the display.
Press the BAND button to select AM or FM.
NOTE: If you select the FM band, be sure to raise the FM Rod Antenna and extend it to its full length.
4 |
|
2 | 1 |
5 |
2 |
1 |
6 |
Press the Tuning/CD Skip/Search 
❶or 
❷ button to select a station (see Tuning note below).
NOTE: If the FM band is selected and you have tuned to an FM Stereo station, the FM Stereo indicator will light in the display.
Adjust the BASS BOOST button ❶ and VOLUME control ❷ as desired.
When you have finished listening, press the POWER button to turn the unit off.
TUNING:
MANUAL TUNING: Repeatedly press the Tuning/CD Skip/Search 
or 
to manually advance the frequency in the display up or down until the desired frequency appears.
AUTOMATIC TUNING: Press and hold the Tuning/CD Skip/Search 
or 
until the frequency in the display starts to scan, and then release the button; the tuner will search and then stop on the next strong station it finds. Repeat this procedure until the desired frequency appears in the display.
Hints for Better Reception
FM - Make sure that the telescopic FM Rod Antenna is raised and extended to its full length. You may have to vary the direction of the antenna to find the strongest signal for each FM station.
AM - The AM ferrite bar antenna is located inside the unit. It may be necessary to turn the unit slightly so that the internal antenna is pointing in the direction of the AM transmitter. You may have to experiment to find the position that provides the strongest reception for each of your favorite AM stations.
7
