HEADPHONE JACK
The headphone jack is located on the right side of the cabinet and covered by a silicon rubber gasket. Lift the gasket to expose the headphone jack but do not remove the gasket from the cabinet.
Insert a set of stereo headphones, not included, into the headphone jack. The built in speaker is automatically shut off when headphones are connected.
Note: When using headphones reduce the volume to a low level before you put the headphones on. Then put the headphones on and gradually increase the volume to a comfortable listening level.
After disconnecting the headphones be sure to
REPLACING THE BATTERIES
When the sound output becomes weak or distorted it’s time to replace the batteries. Always use a
If the unit will not be used for a long period of time (30 days or longer) it’s a good idea to remove the batteries to prevent possible damage to the unit from battery leakage or corrosion.
BATTERY PRECAUTIONS
Follow these precautions when using batteries in this device:
1.Use only the size and type of batteries specified.
2.Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment. Reversed batteries may cause damage to the device.
3.Do not mix different types of batteries together (e.g. Alkaline and
4.If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury from possible battery leakage.
5.Do not try to recharge batteries not intended to be recharged; they can overheat and rupture. (Follow battery manufacturer’s directions.)
1 2
SR5999_ib111902.p65 | 12 |
19/11/2002, 10:18
