BIRCH LOG PLACEMENT
Before you begin: Do not, handle these logs with your bare hands! Always wear gloves to prevent skin irritation. After handling logs, wash your hands gently with soap and water.
All Logs
The positioning of the logs is critical to the safe and clean operation of this heater. Sooting and other problems may result if the logs are not properly and firmly positioned in the appliance.
Refer to Figure 1 and Figure 1A for the following warning.
Warning: Failure to position the parts in accordance with this diagram or failure to use only parts specifically approved with this appliance may result in property damage or personal injury.
PROPER INSTALLATION SEQUENCE: LS-(18,24,30)B2-1:
(Figure 1)
1.Place rear (#1) log onto two (2) pins on rear log support.
2.Place left, front (#2) log onto two (2) left, front pins on burner pan.
3.Place right, front (#3) log onto two (2) right, front pins on burner pan.
4.Place Y Branch (#4) onto two (2) pins on rear log.
5.Compare the completed log installation with the appropriate photo from pages 7 through 9. Review previous steps to make any necessary adjustments.
6.Log placement is completed.
Replacement Loose Material (glowing embers) Part Number
15999 | |
15970 | |
15970 | |
Platinum Bright Embers |
Note: A single layer of embers is to be used when applying Platinum Bright Embers (alone or in combination with production embers) to the burner.
4
1
3
2
Log Placement LS-(18,24,30)B2-1
Figure 1
The following WARNING applies when log set is installed onto an unvented gas burner assembly.
WARNING: This appliance is equipped for (natural or propane) gas. Field conversion is not permitted.
Page 5 |
