Enerco owner manual 2.4WARNING, MODEL MH12CS, Thermocouple Face Gaurd Heater Relector

HOOK-UP INFORMATION

1.1Heater models MH12C and MH12CS are packaged completely assembled except for metal stand. Propane cylinders are not included with models MH12C and MH12CS.

1.2Remove heater from carton.

1.3Hold heater in one hand and with the other hand hold propane cylinder vertically and carefully turn clockwise into heater valve-regulator until snug. (Careful not to cross-thread)

– Fig. 1 and Fig. 2.

1.4Use only LP-gas cylinders constructed for use with propane only (HD-5) and marked in accordance with the specifications for LP-gas cylinders of the U. S. Department of Transportation (DOT Spec. 39).

1.5Use propane fuel cylinders of not more than 75 cubic inches (2-1/2 pounds nominal water capacity) and connect to cylinder valve outlet connection No. 600 as specified in the Compressed Gas Associations Limited Standard Cylinder Valve Outlet Connection for propane-small valve series.

2.1Grasp heater model by cylinder and hold wire stand with other hand. Slide mounting clip on back of heater onto chrome plated wire stand. Fig. 1 and 2.

2.2Push igniter lead onto end of Sparklite Igniter on Model MH12CS-Figure 2.

2.3Make sure wire stand is on a flat surface in the outdoors. See paragraph 5 for additional assembly procedure.

2.4 WARNING

Never touch heater while in operation to avoid injury. Move heater by grasping the propane cylinder carefully.

2.5 Read pages 3 and 4 before lighting heater.

THERMOCOUPLE

FACE GAURD

HEATER

RELECTOR

MODEL MH12C

VALVE/REGULATOR/#F273607

PUSH BUTTON

SAFETY SHUTDOWN VALVE

KNURLED LOCK NUT

CYLINDER - NOT SUPPLIED

WIRE STAND

Figure 1

IGNITER LEAD

SPARKLITE IGNITER

MODEL MH12CS

Figure 2

Mr. Heater Gas-Fired Infra-Red Portable Heater 3 Operating Instructions and Owner’s Manual