LIGHTING / OPERATING INSTRUCTIONS FOR USE WITH DISPOSABLE 1 LB. PROPANE CYLINDERS:
WARNING: Always inspect propane cylinder and heater propane connections for damage, dirt, and debris before attaching propane cylinder. Do not use if head of cylinder is damaged, punctured or deteriorated.
ALWAYS ATTACH OR DETACH CYLINDER OUTDOORS AWAY FROM FLAMES, OTHER IGNITION SOURCES, AND ONLY WHEN HEATER IS COOL TO TOUCH. NEVER SMOKE WHEN ATTACHING OR REMOVING PROPANE CYLINDER OR MAKING REMOTE CONNECTIONS!
•Use only
•Use only 16.4 oz. (1 lb.) disposable cylinders that mate with No. 600 valve connection.
•Heater and attached cylinder(s) must be in an upright position during operation.
•Make sure
•Screw 1 lb. disposable
•Check cylinder(s) connection for leaks with soapy water at the threaded connection under the domed plastic cover where the cylinder screws into the tank swivel. SEE WARNING!
•Depress the Control Knob and turn counterclockwise to the pilot postion.
Fan Switch
Control Knob
Figure1
•Hold Control Knob down in the pilot position for
•While holding down the Control Knob, rotate clockwise to the OFF position and immediately turn back to the pilot position, a spark will be generated at the pilot assembly and the heater should light.
•If the heater does not light on the first attempt, repeat the procedure.
•Once the pilot has lit, hold the Control Knob down for an additional 30 seconds to heat the thermocouple. After 30 seconds, release the Control Knob and the pilot should remain lit.
•If the pilot goes out repeat the lighting procedure.
•After lighting pilot, release Control Knob. Control Knob should return to fully extended position. To operate heater slightly depress knob and gently turn to lock in desired position.
•Turn control knob to “LO” or “MD” position to light heater. Leave on “LO” or “MD” position until first burner tile has turned bright orange.
•After first burner tile has turned bright orange, adjust heat output by turning Control Knob to desired position (“LO”, “MD” or “HI”)
Warning:
DO NOT OPERATE HEATER UNLESS CONTROL KNOB IS LOCKED IN A POSITION MARKED “HI”, “MD”, “LO” or “PILOT”. NEVER SET CONTROL KNOB BETWEEN LOCKED POSITIONS. POOR COMBUSTION AND HIGHER LEVELS OF CARBON MONOXIDE MAY RESULT.
•For added heat circulation turn red fan switch to on. The fan switch is located just left of control knob side handel support. See Figure 1.
•Installation of 4
•Heater can also be powered by electrical adapter F276127. Required adapter to be 6 volt DC up to 800 milliamp current with positive tip polarity. See figure 2.
•To shut off heater, slightly push down and turn Control Knob clockwise to “OFF” position.
•CAUTION: After turning heater off, wire guard will remain hot. Allow to thoroughly cool before storing.
•Do not operate, store or remove cylinder(s) near flam- mable items or ignition sources.
•
Mr. Heater Big Buddy/Tough Buddy | 5 | Operating Instructions and Owner’s Manual | 05/06 | 78438CAL Rev. L1 |