Enerco MH42T operating instructions HOOK-UP Information, LP Cylinder

HOOK-UP INFORMATION

1.1Heater model MH42T is packaged completely assembled. Propane cylinders are not included with heater models.

1.2Remove heater assembly from carton.

1.3Place the slots of the black collar mounting bracket assembly onto the collar of the bulk tank (see Fig. 1)

CAUTION:

BE SURE THE LOCKING KNOB ON THE COLLAR MOUNT- ING BRACKET ASSEMBLY IS OUTSIDE THE COLLAR ON THE BULK TANK. Tighten the black knob against the collar of tank.

1.4Check reflector of the heater (See Fig. 1) and the collar mounting bracket assembly with the three #6-32 x ½ screws and #6-32 Keps hex nuts. Be sure screws and nuts are secure and tight.

1.5Make sure tank valve is in “OFF” position (clockwise).

1.6Make sure regulator knob is in “OFF” position by turning knob clockwise to off.

1.7Carefully screw POL nut directly into bulk tank valve finger- tight, turning counterclockwise; then with a 7/8” open end wrench tighten the POL fitting, hard.

1.8Always connect the heater to bulk tank in the outdoors or in a well ventilated area. NEVER connect heater to bulk tank near an open flame.

1.9Use only LP-gas cylinders constructed for use with propane only (HD-5) and marked in accordance with specifications for LP-gas cylinders of the U. S. Department of Transportation (DOT Spec. 39).

1.10Read pages 3 and 4 before lighting heater.

WARNING

Never touch heater while in operation to avoid injury. Move heater by grasping the propane cylinder carefully.

REFLECTOR

COLLAR

MOUNTINGHOSE ASSEMBLY BRACKET

REGULATOR KNOB

LOCKING KNOB

TIGHTEN

POL NUT

MODEL MH42T

Figure 1

LP CYLINDER

Mr. Heater Gas-Fired Infra-Red Portable Heater 3 Operating Instructions and Owner’s Manual