![](/images/new-backgrounds/1118158/11815871x1.webp)
Hardware Installation
Mounting on a wall or the ceiling– The access point should be mounted only to a wall or wood surface that is at least
a.Using the mounting bracket, mark the position of the four screw holes on the wall or ceiling. For concrete or brick walls or ceilings, you will need to drill holes and insert wall plugs for the screws.
b.Position the mounting bracket over the wall or ceiling screw holes, then insert the included screws and tighten them down to secure the bracket firmly to the wall.
c.Attach the access point to the mounting bracket. Line up the two mounting points on the bracket with the two mounting slots on the bottom of the access point (see the following figure). Place the mounting points of the bracket into the mounting slots of the bracket, slide it into position so that the bracket fastening screw on the access point lines up with the tab on the bracket.