3
Configuration
Once a TAG appliance is physically installed into a rack, you need to connect a monitor and a USB keyboard, connect the power cord and network cable, and power it on (see Figure 1‐1 and Figure 1‐2). Then, you must go through the initial configuration process described in this chapter.
This chapter also includes information on how to change your appliance settings following your initial configuration, Changing Trusted Access Gateway Settings on page 3‐3.
Pre-Configuration Tasks
The following information is needed prior to executing any of the steps in this chapter:
•Appliance Hostname, IP address, and netmask
•Gateway IP address
•Management Server IP address
Configure the Appliance
Note: To upgrade the
To configure the appliance to run the Trusted Access Gateway software:
1.Login as root, with no password, and then press Enter.
You will receive a warning that there is no root password detected, and be asked if you would like to set a root password.
2.Highlight Yes, and press Enter.
3.Enter the new password, re‐enter the password, and press Enter.
Note: Enterasys recommends that all passwords be at least eight characters in length.
The CONFIGURE NETWORK screen appears.
4.Highlight Yes to configure your network, and press Enter. The ENTER HOSTNAME screen appears.
5.Enter the hostname for the appliance, then highlight OK and press Enter. The SETUP IP ADDRESS FOR “your host name” screen appears.
