1000 ICS

Start

®

Here

EPSON

 

 

 

1 Unpack Your EPSON 1000 ICS

1 Make sure you have all the parts shown here. If any parts are missing, contact EPSON as described in your Basics book.

You’ll also need a USB cable (not included) to connect the EPSON 1000 ICS to your computer.

2 Remove any tape and packing materials, as shown.

Do not remove sticker from USB

port.

Note: There may be additional packing materials or tape in locations different from the ones shown in these illustrations. Do not remove the sticker covering the USB port.

2 Releasel the Transportationi Lock

1 Press the release button on the right side, then lift up the scanner, as shown.

2 Peel off the tape and remove the plastic piece from the front of the ink cartridge holders. Remove the packing tape from the transportation lock.

3 Slide the transportation lock to the left.

4 Carefully lower the scanner back down into place.

3 Attach the Paper Support

Insert the paper support into its three slots.

4Plugl In Your EPSON 1000 ICS

Plug the EPSON 1000 ICS into a grounded electrical outlet.

Do not connect the USB cable yet.

5 Installll the Ink Cartridgesi

1 Press the Operate button. The Operate light comes on and the scanner carriage and print head move.

Operate button

2 Press the release button on the right side, then lift up the scanner.

3 Unwrap the ink cartridges and remove the yellow tape.

Warning: Keep ink cartridges out of the reach of children. If ink gets on your skin, wash the area thoroughly with soap and water. If ink gets in your eyes, flush them immediately with water.

4 Lift up the ink cartridge clamps.

5 Insert the ink cartridges with the labels face-up.

6 Press down the ink cartridge clamps until they snap shut.

7 Carefully lower the scanner back down into place.

8 Press the Copy button to begin charging the ink delivery system.

Charging takes about two minutes. The Operate light flashes and the EPSON 1000 ICS makes various sounds. Don’t turn it off while the Operate light is flashing or you’ll waste ink.

Caution: Don’t open the clamps to remove a cartridge except to replace it with a new one. Once you remove a cartridge, you can’t reuse it, even if it contains ink. You must install both cartridges and leave them installed for all types of printing. To avoid damaging the EPSON 1000 ICS, never move the print head by hand.

Turn over