EPSON Perfection 1670 Photo

Placing Film on the Scanner

The scanner cover has a built-in transparency unit. To scan negative film or slides, you need to remove the reflective document mat from the cover and place the film in a holder on the scanner glass.

1.Make sure the transparency unit cable is connected to the back of the scanner.

2.Lift the scanner cover all the way up and slide the reflective document mat up and off the scanner cover.

4.Place the film holder in the correct position for your film type. If you are scanning slides, place the holder on the scanner first, then place the slides in the holder.

Be sure to match the letter on the film holder tab with the corresponding letter on the scanner.

ANegatives:

(A) If you are scanning

 

the first 3 frames of

 

the negative strip,

B

place the film holder

 

against the left edge

 

of the scanner.

 

(B) For the last 3 frames, rotate the position of the film holder and place it against the right edge of the scanner.

C

Slides (C)

Place the holder on the scanner glass, then put the slides in the holder.

3.Slide the negative strip into the film holder with the film’s shiny base side facing down.

Make sure the narrow calibration window at the top of the film holder is clean and uncovered to ensure an accurate scan.

5. Close the scanner cover.

Make sure there is no dust on the slides or negatives.

You can select the Dust Removal setting in EPSON Scan to improve your scan.

If your scanned image is upside down, you can use

the Rotate buttons in EPSON Smart Panel (not available in all Smart Panel applications) or in Preview mode in EPSON Scan. You can also rotate the image in most image editing applications.

6/03

EPSON Perfection 1670 Photo - 5