Epson PowerLite Cinema 200 Projector
Adjusting the Color
You can use the Color Adjustment settings to
1.Select Picture Quality, then click Adjustment of image.
2.Select one of the following modes, then click Adjust.
❏RGB: Adjusts the offset, gamma, and gain for each signal color. Use Offset to adjust darker shades, Gamma for intermediate shades, and Gain for the lightest shades.
❏RGBCMY: Adjusts the hue and saturation for each of six colors, as shown on the color palette below. After moving a slider bar, click Apply.
Adjust the hue (red, green, blue, cyan, magenta, yellow)
Adjust the saturation
Saving and Recalling Picture Settings
Once you’ve adjusted the picture to your liking, you can save your settings in the projector’s memory. Then you can use the remote control (or Cinema Color Editor) to recall them for future use. You can also rename or delete memory settings stored on the projector.
1.Select Picture Quality, then click Memory management.
Use these settings to select, register, or edit a memory setting
Cleaning and Replacing the Air Filter
Clean the air filter on the bottom of the projector after every 100 hours of use. If it’s not cleaned periodically, it can become clogged with dust, preventing proper ventilation. This can cause overheating and damage the projector.
1.Turn off the projector and wait for the P power light to stop flashing.
2.Unplug the power cord and disconnect any cables.
3.Turn the projector over. Then use a small vacuum cleaner designed for computers and other office equipment to clean the filter. If you don’t have one, gently clean the filter using a very soft brush, such as an artist’s paintbrush.
If the dirt is difficult to remove or the filter is broken, replace it. Contact your dealer or call Epson at (800)
4.If you need to replace the filter, release the tab and lift open the cover.
5.Remove the old filter and replace it with a new one.
6.To replace the cover, insert the tabs and press down until the cover clicks into place.
2.Click one of the following:
❏Select to use a memory setting stored on the projector
❏Register to create a new memory setting
❏Edit to change the name of an existing setting
See the User’s Guide for details.
10 - Epson PowerLite Cinema 200 Projector | 1/04 |