Epson PowerLite Cinema 200 Projector
Locking the Projector
You can lock the projector to prevent the image from being accidentally changed once it’s adjusted, and to keep children from using the projector without adult supervision.
1.Press the Menu button on the remote control.
2.Use the menu navigation buttons to open the Setting menu, then open the Operation menu and select Lock Setting.
3.Choose from these options:
❏Focus Lock to prevent the focus from being changed.
❏Zoom Lock to prevent the picture size from being changed.
❏Child Lock to make it more difficult to turn on the projector from the control panel (but does not affect operation of the remote control).
To turn on the projector, either use the remote control, or press and hold the projector’s P Power button for at least 3 seconds.
❏Key Lock to disable all the buttons on the projector’s control panel.
Basic Image Adjustments
Once the projector is turned on, use these functions to adjust the image.
Selecting the Image Source
If you don’t see the image you want, press the Source button on the remote control that corresponds to the port to which your video equipment is connected. For example:
To select the image source
connected to the Video port . . . | . . . press the Video button |
Focusing and Zooming the Image
To adjust the sharpness or size of the image:
1.Press the Focus or Zoom button on the projector or remote control.
You see this screen:
2. Use the 
arrow buttons to adjust the image.
Note: If you use the remote control, you can stand close to the screen while focusing the image. This lets you adjust the picture more precisely.
3. Press ESC when done.
Inverting and Mirroring the Image
If the image is
1.Press the Menu button on the remote control.
2.Use the menu navigation buttons to open the Setting menu, then open the Screen menu and select Projection.
3.Choose from these options:
❏Front if the projector is located in front of the screen (for example, on a table).
❏Front/Ceiling if the projector is located in front of the screen and mounted overhead.
❏Rear if the projector is located behind the screen.
❏Rear/Ceiling if the projector is located behind the screen and mounted overhead.
Note: If you still don’t see an image after selecting the source, check the troubleshooting tips on page 7. You can also use the Source button on the projector’s control panel.
Selecting the Input Signal
If you’re using the projector’s Input A port, select the correct setting for the type of video equipment you’ve connected to it:
1.Press the Menu button on the remote control.
2.Use the menu navigation buttons to open the Setting menu, then open the Input Signal menu and select Input A.
3.Choose from these options:
❏YCbCr for a video player that outputs an NTSC signal.
❏YPbPr for a video player that outputs an HDTV signal.
❏
1/04 | Epson PowerLite Cinema 200 Projector - 5 |