ActionPrinter 2250
•When you want to push the paper support back into the paper cassette, first remove paper from the cassette. Then hold down the locking tab while pushing the paper support in.
•The default page length for the paper cassette is 65 lines
•You can switch to manual insertion or to the push tractor without removing the paper cassette.
Loading paper manually
You can load single sheets of paper from the rear manual insertion slot. (if you’ve installed the push tractor, remove it before loading paper manually.)
1.Place the printer in the upright position and turn it on.
2.Next, lower the flap on the rear slot. Then insert a single sheet into the slot, aligning the paper edge with the arrow mark on the printer case. The page loads automatically. When the printer receives data, it begins printing.
tk sure to raise the flap when not using manual insertion.
a~~CAUTION: Be sure to turn on the printer before you insert the page into the slot. If you bun on the printer after you insert paper, the printer prints on the platen without
. You can adjust the
•When you want to switch to the paper cassette, press the LF/FF button without inserting a page into the rear slot. The printer loads a page from the cassette.
Using continuous paper with the push tractor
You can use the push tractor to print on continuous paper from 101 mm (4 inches) to 254 mm (10 inches) wide.
Note: The tractor is an option (part number C80026*).
Installing the push tractor
1.Make sure the printer is turned off and is in the flat position. Remove the paper guide.
2.Make sure the
3.Hold the tractor as shown and fit the edges of both sides into the slots at the back of the printer. Then lift it straight up until YOU hear the unit snap into place.
4.Raise the
7/l 4/92 |