3Set up the remote control
Pull out the insulating tape that protrudes from the battery holder.
The remote control is ready for use.
Multipurpose Entertainment Projector
EPSON® PowerLite® 30c
5 Adjust the image
1 If you need to raise the image, press the foot adjust buttons and lift the front of the projector. Release the buttons to lock the feet in the position you want.
If you need to straighten the image, raise or lower an individual foot.
4 Plug in and turn on
1 Remove the lens cover.
2 Connect the power cord to the projector and plug the other end into a grounded outlet.
The 
power light turns orange.
3 Turn on the other equipment connected to the projector.
4 Press the 
Power button on the projector or remote control. The 
power light flashes green, and the projector lamp comes on in about 15 seconds.
5 Start your video. If you have connected more than one video source, press the Computer or
the remote control to select the one | Source buttons |
| |
you want to watch. |
|
Note: If you connected a laptop computer and no image is being projected, you may need to set up the laptop to output signals externally. See your laptop’s documentation for instructions.
For additional instructions on connecting to a computer, see your User’s Guide on the
|
| Power |
Computer | Color Mode | |
Menu | A/V Mute | Freeze |
Enter
AutoESC
2 Rotate the focus ring to sharpen the
| image. |
|
|
|
|
|
3 | If your image is |
|
|
|
| |
| or reversed, you need to change |
|
|
|
| |
| the setting in the Advanced menu. |
|
|
| ||
| Press the Menu button on the |
|
|
|
| |
| remote control and use the Enter |
|
|
|
| |
| button to choose the Advanced |
|
|
|
| |
| menu. Then select the correct |
|
|
|
| |
| setting for your setup. |
|
|
|
|
|
4 | If a computer is connected, do this after projection starts. Press the | |||||
| Menu button on the remote control, and use the Enter button to |
| ||||
| choose the Video menu. Go to the Input Signal option and change | |||||
| it to RGB. |
|
|
|
|
|
5 | If your image looks like | or | , first make sure the projector is facing | |||
| the screen squarely. Then, if necessary, press the Keystone button on the | |||||
| projector’s control panel until the image is corrected. (You also can do this | |||||
| using the projector’s Setting menu. See your User’s Guide on the | |||||
6 | To select the best color mode, press the |
| Power |
| ||
| Color Mode button on the remote control |
|
|
| ||
| repeatedly to move through the options. | Computer |
| |||
|
|
|
|
| ||
7 |
|
|
|
|
| Color Mode |
To boost the projection quality of films, first | Menu | A/V Mute Freeze | button | |||
|
|
| ||||
| attach the EPSON cinema filter to the lens. |
|
| |||
| Then, press the Menu button on the remote |
|
|
| ||
| control, go to the video menu, and change |
| Enter |
| ||
| the EPSON Cinema Filter setting to ON. |
|
| |||
|
|
|
| |||
|
|
|
| Auto | ESC |
|
See your User’s Guide on the
If you see a blank screen
If you see a blank screen or the No Signal or
Not Supported message, check the following:
•Make sure the lens cover is off.
•Make sure your power cord and
video cable are connected securely. | No signal ( ? | Help) |
|
|
Turning off the projector
1 When you’re finished using the projector, first turn off the video source.
2 Press the 
Power button on the projector or remote control.
3 When you see the confirmation message, press the
Power button again. The 
power light flashes orange as the projector cools down.
Caution: Never unplug the projector when the 
power light is green or flashing orange.
•If the 
power light is orange, press the 
Power button on either the remote control or the projector’s control panel.
•Make sure the correct input source is selected. On the remote control, press the Computer or
•Try turning off your video equipment or computer and restarting it.
•If mute mode is active, press the A/V Mute button on the remote control to resume projection.
•If you connected a computer to the projector, it may be necessary to change the image signal to the projector. See “Troubleshooting” in your User’s Guide on the
EPSON is a registered trademark of SEIKO EPSON CORPORATION. PowerLite is a registered trademark of Epson America, Inc.
General Notice: Other product names used herein are for identification purposes only and may be trademarks of their respective owners. EPSON disclaims any and all rights in those marks. Copyright © 2002 by Epson America, Inc. Printed in USA. 8/02