Epson 310 Series

*411645900*

*411645900*

If anything is missing, contact Epson as described on the back.

Note: The model name of your product may vary slightly from the one shown above.

The included CD and documentation apply to all products in the series.

Caution: Do not open ink cartridge packages until you are ready to install the ink.

Cartridges are vacuum packed to maintain reliability.

Canada only: For French speakers, remove sticker(s) from the backing sheet and

place over corresponding text on the control panel.

Remove all protective materials.

Unpack

Start Here

Make settings

Auto Answer/

Space

Redial/Pause

Stop/

Clear Settings

B&W

Color

Speed Dial

Group Dial/

Backspace

1 Select your language.

Press or to select the desired option.

Press OK when done.

2 Press or to select your country/region, then

press OK.

3 For the Daylight Saving Time setting, press

or to select Summer if your region uses

Daylight Saving Time and it’s currently in effect.

(DST is effective from spring through summer.)

Otherwise, select Winter to turn off the setting.

Press OK.

4 Press or to select the date format, then

press OK.

5 Use the numeric keypad to set the date, then press OK.

6 Press or to select the time format, then

press OK.

7 Use the numeric keypad to set the time.

8 If you selected 12h as the time format,

press or to select AM or PM.

9 Press OK when done.

Note: You can change the date and time settings by pressing the Copy button,

pressing the Menu button, selecting Maintenance, then selecting Date/Time.

1 Open the paper support and pull up the extensions.

2 Pull out the output tray extensions, and raise the stopper.

Note: If you are using legal-size paper, do not raise the stopper.

3 Squeeze the edge guide and slide it left.

Tip: If the feeder guard is in the way, ﬂip it forward.

4 Load paper against the right edge and behind the tab, with the printable

side face up.

Note: Don’t load the paper sideways; always load it

short edge first.

5 Slide the edge guide over.

5Load paper

3 Remove only the yellow tape from each cartridge.

Caution: Don’t remove any other seals or the cartridges may leak.

4 Insert the cartridges in the holder for each color.

5 Press each cartridge down until it clicks.

6 Close the ink cartridge cover. Press it down until it clicks.

7 Lower the scanner.

8 Press the OK button to charge the ink. Charging takes about

21/2 minutes.

Note: Your WorkForce 310 Series ships with full cartridges and part of the ink

from the ﬁrst cartridges is used for priming the WorkForce 310 Series.

Caution: Don’t turn off the WorkForce 310 Series while the ink system is

charging or you’ll waste ink.

(Included for

Canada only)

1 Connect the power cable.

Caution: Do not connect to your computer yet.

2 Press the On button.

Turn on

Series

Phone cord Power cord

Install ink cartridges

Note: Don’t load paper before installing the ink cartridges.

1 Lift up the scanner, then open the cartridge cover.

2 Shake the ink cartridges gently 4 or 5 times, then unpack them.