Epson 3200 Connect the Scanner, If you’re using USB

Remove sticker

3 Connect the cable for the built-in transparency unit to the round connector on the back of the scanner. You may need to raise the scanner cover and twist the cable to insert it.

Make sure the

arrow faces up

4 Connect either the USB interface cable that comes with your scanner or an optional IEEE 1394 (FireWire) cable. Don’t connect both.

If you’re using USB...

Plug the square end of the USB cable into the scanner’s

USB port. Then plug the flat end into any available USB port on your computer or USB hub.

Note: Your scanner may not work correctly if you use a USB cable other than the one supplied by EPSON or if you connect your scanner to a multi-level USB hub system.

If you’re using IEEE 1394 (FireWire)...

Plug one end of the IEEE 1394 cable (not included) into the scanner’s IEEE 1394 port. Then plug the other end into the IEEE 1394 (FireWire, iLink) port on your computer.

5 Plug the scanner’s power cord into a grounded electrical outlet.

6 Press the power button on the front of the scanner to turn it on. The scanner lamp comes on.

Remove the sticker from the back of the scanner.

After your software is installed, it’s time to get connected.

1 Remove the sticker from the transportation lock. Use a coin to turn the lock clockwise one-quarter turn to unlock the scanner carriage.

Connect the Scanner