SWLUS
800 Service
Manual
General Description
1.4.4 Initial ink Charge
When the printer is to be set up for primary use, whole ink supply path of the printer must be filled
with a new ink, by performing the initial ink charge operation.
[Step 1]
[Step
2]
[Step 3]
[Step 4]
Turn the printer on and press the PAUSE button to pause the printer.
Open the printer cover and hold down the
ALT
button until the
printhead
moves to the
ink cartridge replace position.
Install the ink cartridge on the
printhead,
and press the
ALT
button again to move the
printhead
to capping position. Then, turn off the printer.
Turn the printer on while holds down the
ALT
and the PAUSE buttons to start the initial
charge operation.
The PAUSE LED blinks while the initial ink charge operation is in progress, and when it completes,
the printer automatically becomes ready state.
W
The ink cartridge must be installed just after unpacking the package.
H
The initial ink charge operation should not be
pe@ormed
more than
trm”ce
on the same
printer. It, otherwise, consumes too much ink in the ink
carh”dge
and shorten the waste
ink tank life.
1.4.5 Error Conditions
he
printer detects various errors and indicates them with the LED indicators and the buzzer.
Table 1-8. Error Codes
Error PAPER
LED
Paper out
ON
Paper jam BLINKS
I
Ink low
●
1
I
OFF
Inkend
I
OFF
Waste ink tank
OFF
over-flow
INK END
LED
OFF
OFF
BLINKS
ON
ON
OFF
ON
PAUSE
LED Buzzer
OFF
V4
x 3 times
OFF
[
V4
x 3 times
No beeps
=t==
=-l--==
BLINKS
V+
x
3
times
Recovery
Load the paper and press the
buttons as follows:
1. PAUSE
2. LOAD/EJECT
Same as above.
Press PAUSE button and
replace the ink cartridge with
a new one. Then, press
PAUSE button again to
resume printing.
●
2
Replace the ink cartridge and
press
PAUSE button.
Install the ink cartridge and
mess
PAUSE button.
Turn off the printer, and turn
it on again.
Service
maintenance
required. (Replace the waste
ink absorbing material and
reset the protect counters.)
Notes: V :
0.1 second beep
4 :
0.5 second beep
+
:
0.1 second
intetval
+
:
0.2 second interval
‘1:
This is
not treated as an error.
*2:
It
is not necessary to replace the ink cartridge until the printer detects the ‘Ink
End’ error.
Rev. A 1-13