STYLUS 800 Service Manual Disassembly and Assembfy
3.2.1 CASE, UPPER Removal
[Step 1]
[Step
2]
[Step
3]
[Step
4]
[Step
5]
[Step
6]
Remove the COVER, PRINTER by releasing the tabs holding it to the CASE, UPPER.
Remove the SUPPORT, PAPER by releasing the tabs holding it to the CASE, LOWER.
Remove the GUIDE, PAPER, REAR.
Remove the CONTROL PANEL. (Release the tab by inserting a screwdriver into the hole
in the CASE, UPPER, as shown in figure below.)
Remove 2 screws (CBB screw (M3 x 12) x 2).
Release 3 tabs by inserting a flathead screwdriver into the holes at the bottom of the
CASE, LOWER, as shown in figure below.
Holds the upper case firmly and pulling it as to remove, while you releasing the tabs.
[Step 7] Remove the CASE, UPPER by lifting the front side.
Cont~ol
Panel
Figure 3-2. CASE, UPPER Removal
Rev. A
3-3