Epson 5350, 7350 Using the Remote Control, Note:

EPSON PowerLite 5350/7250/7350 Projector

Using the Remote Control

The remote control uses a line-of-sight infrared signal. To use the remote control, point it towards one of the infrared receivers located at the front and back of the projector. You can use the remote control up to about 32.8 feet (10 meters) from the projector. (This distance may be shorter if the remote control batteries are low.) You must also be within a ± 30° angle from the front or rear receiver.

Note: The projector may not respond to remote control commands

in these conditions: ambient light is too bright; a certain type of fluorescent light is present; a strong light source (such as direct sunlight) shines into the infrared receiver; or other equipment emitting infrared energy is present (such as a radiant room heater). Correct these conditions to use the remote control or control the projector from a computer.

	Front
Freeze			IR output
A/V Mute		Power	Power
	Freeze
E-Zoom	A/V Mute
			remote control
	E-Zoom	R/C ON
Special effects		OFF
			On/Off
buttons (1-5)	3
		4
	2
Enter (pointer)	1	5
button	Enter
illumination	Esc
Esc button

Back

battery cover

cover lock

Open the cover just below the Esc button to access additional remote control commands.

Power

Freeze

A/V Mute

R/C ON

E-ZoomOFF

		3
	2	4
	1		5
	Enter
Menu		Esc	Help
	Menu	Help
Comp1	Comp1	BNC	BNC
S-Video	S-Video	Video	Video
Auto	Auto	Resize
			Resize
	P in P	Preset

P in P - Volume +

Preset

Volume

8/99 EPSON PowerLite 5350/7250/7350 Projector - 5