EPSON PowerLite 600p/800p/810p

Adjust the image

Remove the lens cap and rotate the focus ring1 to sharpen the image.

zoom ring

focus ring

Note: If you see a blank screenafter focusing,
see the box below.

 

Rotate the zoom ring to reduce or enlarge the image.2 (You can also move the projector closer to or farther from the screen.)
Raise the image as needed. To do this, press the foot release

3 button and lift the front of the projector. Once the image is positioned where you want it, release the button to lock the foot in position. If you need to straighten the image, rotate the round adjustable foot at the back of the projector.

back adjustable foot

4

If your image looks like

or

, press the Sync+ or Sync–
(vertical Keystone) button to correct the shape of the image.

 

If your image looks like

or

, you’ve placed the projector

5 at an angle to the screen. Move it directly in front of the center of the screen, facing the screen squarely. Or press the Tracking+ or Tracking– (horizontal Keystone) button to correct the shape.

If you see a blank screen

If you see a blank screen or the No Signal message after turning on your laptop, check the following:

¡Make sure the power light is green and not flashing and the lens cover is off.¡Try turning off the laptop and restarting it.

¡If you’ve connected more than one computer and/or video source, you may need to press the Computer/YCbCr or Video button on top of the projector. (Allow a few seconds for the projector to sync up after pressing it.)

¡Make sure your cable is connected securely.

If you’re using a Windows laptop:

¡Press the function key that lets you display on an external monitor.

It may have an icon such as , or it may be labelled CRT/LCD. You may have to hold down the Fn (function) key while pressing it. (Allow a few seconds for the projector to sync up after pressing it.) Check your laptop’s manual or online help for details.

On most systems, the or CRT/LCD key lets you toggle between the LCD screen and the projector, or display on both at the same time.

¡You might need to use the Display utility in the Control Panel to enable both the LCD screen and external monitor port.

If you’re using a Macintosh:

1.From the Apple menu, select Control Panels, then click Monitors or Monitors and Sound.

2.Click the Arrange icon.

click here

drag one monitor icon on top of the other

3.Drag one monitor icon on top of the other. This lets you display on the projector screen as well as the LCD screen.

If this option isn’t available, you may need to select one of the Simulscan resolution settings:

1.Perform step 1 above, if necessary.2.Click the Monitor icon.

click here

select a Simulscan resolution

3.Select a Simulscan resolution as shown. (Allow a few seconds for the projector to sync up after making the selection.)

EPSON is a registered trademark of SEIKO EPSON CORPORATION. PowerLite is a registered trademark of Epson America, Inc. Copyright © 2001 by Epson America, Inc. Printed in USA 7/01

CPD-12789