EPSON Stylus Photo 700

Replacing an Ink Cartridge

Caution:

To ensure good results, use genuine EPSON cartridges and do not refill them. Other products may cause damage to your printer not covered by EPSON’s warranty.

When a B black or A color ink out light flashes, the indicated cartridge is low on ink. This is a good time to make sure you have a new cartridge. When the light stays on, the cartridge is empty and you need to replace it. You cannot print if either ink cartridge is empty.

Use these EPSON ink cartridges within six months of installing them and before the expiration date on the package:

❏Black ink cartridge: S020093❏Color ink cartridge: S020110

Removing an Empty Ink Cartridge

You can replace a cartridge when the B black or A color ink out light is either flashing or on. Follow these steps:

1.Make sure the printer is turned on and not printing.2.Determine which cartridge needs to be replaced.3.Lower the output tray and raise the printer cover.

Warning:

If ink gets on your hands, wash them thoroughly with soap and water. If ink gets into your eyes, flush them immediately with water.

Installing the New Cartridge

Once you have removed the empty cartridge, you’re ready to install the new one. Follow these steps:

1.Remove the new ink cartridge from its packaging.

2.Remove only the yellow part of the tape seal on the top of the cartridge. Do not remove the white part. (It’s OK if the tape does not exactly tear off along the dotted line.)

Caution:

You must remove the yellow tape seal from the top of the cartridge; leaving the tape on will permanently damage it. Do not remove the clear seal from the bottom of the cartridge; ink will leak out.

don’t remove

don’t remove

remove

remove

Note:

If you press the R cleaning button when neither ink out light is flashing or on, the printer cleans the print head as described on page 10. If you need to replace an ink cartridge before the lights flash (because the ink is too old, for example) follow the instructions in “Replacing an Outdated Ink Cartridge.”

4.Press the R cleaning button and hold it for three seconds.

The print head moves slightly to the left and the P power light begins flashing. (The print head returns to its home position if you don’t proceed to step 5 within 60 seconds.)

5.Pull up the ink cartridge clamp. The cartridge rises up from its holder.

Caution:

Don’t open the clamp or remove a cartridge except to replace it with a new one. Once you remove a cartridge, you can’t reuse it. Even if the cartridge contains ink, reusing it may damage the print head.

6.Lift the cartridge out of the printer and dispose of it carefully.7.Follow the steps in the next section to install the new ink cartridge.

black ink cartridge

color ink cartridge

3.Lower the ink cartridge into its holder with the label facing up and the arrow pointing to the back of the printer. The larger cartridge (color) goes on the right, the black ink cartridge on the left.

4.Press down the ink cartridge clamp until it locks in place.

5.If you need to replace the other ink cartridge, remove it as described in “Removing an Empty Ink Cartridge.” Then follow steps 1 through 4 in this section.

6.Press the R cleaning button and close the printer cover.

The printer moves the print head and begins charging the ink delivery system. (Even if you don’t press the button, ink charging begins 60 seconds after you close the clamp.)

The P power light flashes and the printer makes various sounds. Charging takes about two minutes. When it’s finished, you can print again.

Caution:

Never turn off the printer while the P power light is flashing, unless the printer hasn’t moved or made any noise for more than 5 minutes.

3/98

EPSON Stylus Photo 700 - 9