Epson 810 Series

*411685500*

*411685500*

If anything is missing, contact Epson as described on the back.

Caution: Do not open ink cartridge packages until you are ready to install the ink.

Cartridges are vacuum packed to maintain reliability.

Canada only: For French speakers, remove the sticker from the backing sheet and

place it on the right side of the control panel.

Remove all protective materials from the printer, including from inside the

paper cassette.

1 Raise the scanner and remove the transportation lock.

2 Store the transportation lock as shown.

3 Lower the scanner.

Unpack

Start Here

Make settings

1 Select your language and country.

Touch the screen to select the desired option. Press or to see more

countries.

2 For the Daylight Saving Time setting, select Summer if your region uses

Daylight Saving Time and it’s currently in effect. (DST is effective from

spring through summer.) Otherwise, select Winter to turn off the setting.

Press OK.

3 Select the date format.

4 Use the numeric keypad to set the date, then press OK.

5 Select the time format.

6 Use the numeric keypad to set the time.

7 Press OK when done.

Note: You can change the date and time settings by pressing the Home button,

selecting Setup, selecting Printer Setup, then Date/Time. For more information on

using and adjusting the control panel, see your Quick Guide.

2 Squeeze the edge guides and slide them out. Then insert paper with the

glossy or printable side face-down.

3 Slide the edge guides against the paper.

4 Lower the photo tray.

5 Squeeze the edge guides and slide them out. Then insert 4 x 6-inch or

5 x 7-inch photo paper with the glossy or printable side face-down.

Note: Make sure the paper ﬁts under the edge guides.

6 Slide the edge guides against the paper.

7 Keep the cassette flat as you insert it.

8 Extend the output tray and flip up the stopper.

5Load paper

Install ink cartridges

Note: Do not load paper yet.

1 Lift up the scanner.

2 Unpack the ink cartridges.

3 Remove only the yellow tape from each cartridge.

Caution: Don’t remove any other seals or the cartridges may leak.

4 Insert the cartridges in the holder for each color. Press each cartridge

down until it clicks.

5 Lower the scanner.

6 Wait while ink charges. Charging takes about 5 minutes.

Note: Your Artisan 810 Series ships with full cartridges and part of the

ink from the ﬁrst cartridges is used for priming the Artisan 810 Series.

Replacement cartridges will print more pages.

Caution: Don’t turn off the Artisan 810 Series while the ink system is

initializing or you’ll waste ink.

(Included for

Canada only)

1 Connect the power cable.

Caution: Do not connect to your

computer yet.

Turn on and adjust

2 Press the On button, then raise the

control panel.

To lower the control panel, press the

Unlock button.

Caution: To avoid damaging your Artisan 810

Series, always press the Unlock button to lower

the control panel.

The paper cassette has 2 trays. The main tray is for letter-size, legal-size,

or 8 x 10-inch paper. The photo tray is for 4 x 6- or 5 x 7-inch photo paper.

1 Pull out the paper cassette. Then slide back the photo tray and lift it up.

Phone cord Power cord

Series