ENGLISH

Advanced Setup – Part 1

Setting the Auto Surround Mode

Set whether or not to store the surround mode last played for the input signal.

The surround mode used at last for the three types of input signals shown below is stored in the memory, and the signal is automatically played with that surround mode the next time it is input.

qAnalog and PCM 2-channel signals (STEREO)

w2-channel signals of Dolby Digital, DTS or other multi-channel format (DOLBY PLIIx Cinema)

eMulti-channel signals of Dolby Digital, DTS or other multi- channel format (DOLBY/DTS SURROUND)

Default settings are indicated in ( ).

1 Press F G to set.

Advanced Setup – Part 2

Speaker Setup

• If the “Auto Setup” procedure has already been performed, there is no need to make this setting.

• Perform this setting if you wish to make the settings for your speaker systems manually.

Setting the Speaker Configuration

F G, ENTER D H

Automatically set the output component and

properties for

the

 

various channels according to the combination

of speakers to

be

 

actually used for surround playback.

 

 

2 Press ENTER to enter the setting and switch to the Speaker Setup.

1

1 2 A u t o S u r r . O F F

2

ENTER

D H F G

[TEST TONE]

ENTER

D H F G

About the button names in this explanation

<> : Buttons on the main unit

[

] : Buttons on the remote control unit

Button name only :

Buttons on the main unit and remote control unit

45

1 Press F G to select “1. Sp”, then press ENTER.

2 Press D H to select the speaker, then press F G to set.

Large:

Select this when using large speakers with ample low frequency reproduction capabilities.

Small:

Select this when using small speakers without ample low frequency reproduction capabilities.

None:

Select this when no speaker is connected.

2sp / 1sp:

Select the number of surround back speakers.

Yes / No:

Select “Yes” when a subwoofer is connected, “No” when no subwoofer is connected.

A subwoofer with sufficient low frequency playback capability can better handle deep bass than most main and surround speakers, and the system’s overall performance will be greatly enhanced when “Small” is set for the main (front) and surround speakers.

When “Front” is set to “Small”, “Subwoofer” is automatically set to “Yes”, and when “Subwoofer” is set to “No”, “Front” is automatically set to “Large”.

3 Press ENTER or H to enter the setting and switch to the Subwoofer Mode Setup setting.

ENGLISH