ENGLISH
Advanced Setup – Part 2
•The distance changes in units of 1 foot each time the button is pressed. Select the value closest to the measured distance.
•Please note that the difference of distance for every speaker should be 20 ft or less.
Setting the Crossover Frequency
Set the frequency (Hz) below which the bass sound of the various speakers is to be output from the subwoofer.
For speakers that are set to “Small”, frequencies under the crossover frequency are cut before the signal is output, and the low frequency component that was cut is output from the subwoofer or the speakers that are set to “Large”.
1 Press F G to set.
40, 60, 80, 90, 100, 110, 120, 150, 200, 250 Hz:
Set as desired according to your speakers’ bass playback ability.
2 Press ENTER or H to enter the setting and switch to the Test Tone setting.
1
1 6 C r . O v e r 1 0 0 H z
2
1 7 T . T o n e Y e s <
•The crossover frequency mode is valid only when subwoofer is set to “ON”, and when one or more speakers are set to “Small”, as
described in section “Setting the Speaker Configuration” (
page 45, 46).
•Set to “80 Hz” when using regular speakers. When using small speakers, we recommend setting to a higher frequency.
Setting the Test Tone
Set the volume of the various speakers so that the sound output from the speakers and the subwoofer seems to have the same volume level.
1 Press F to select “Yes”.
2 Press F G to set, then press H.
Auto:
Adjust the level while listening to the test tones produced automatically from each speaker.
Test tones are automatically emitted from each speaker.
Manual:
Adjust with the speaker from which the test tone is output switched manually.
3 When “Auto” mode is selected: Press F G to adjust the volume.
FL 
C 
FR 
SR 
(2 speakers)
SW
SL 
SBL
SBR
SB | (1 speaker) |
|
The volume can be adjusted within the range
3 When “Manual” mode is selected:
Press D H to select the speaker, then press F G to
4 Press ENTER to finish the Test Tone setting.
5 Press ENTER the setting and switch to the Input Setup.
47
Advanced Setup – Part 2
1
1 7 T . T O N E Y e s <
2
T . T o n e A u t o >
3
T E S T T O N E O N
A U T O - F L
5
•To adjust the channel level separately for the different play modes after setting the channel level, perform the operation on page 30.
¢Adjusting the test tone using the remote control
unit
Adjustment of the test tones using the remote control unit is only possible in the “Auto” mode and only valid in the STANDARD (Dolby Surround and DTS Surround) mode. The adjusted levels are automatically stored for the different surround modes.
1 Press [TEST TONE].
• Test tones are output from the different speakers.
2 Press F G to adjust the volume.
3 Press [TEST TONE].
ENGLISH