DIP switch 1
The table below contains information on switch functions, and the factory setting of each switch. The switches on DIP switch 1 allow you to change interface functions.
Table 1. DIP switch 1
1 | SW Ipin No.1 |
| Function | ( | ON 1 | Off ( | Factory setting ) |
|
|
|
|
|
|
| J |
| 1 - 1 |
| I/F board enable/disable |
| Enable | Disable | ON |
|
|
|
|
|
|
|
|
|
| Buffer enable/disable |
| Enable | Disable | ON | |
|
|
|
|
|
|
|
|
| I | Self test enable/disable | I | Enable | Disable | OFF | |
|
|
|
| I |
| ||
| 1 - 4 |
| Not used. |
| - | - | OFF |
|
|
|
|
|
|
|
|
Jumpers
The jumper is a small terminal used for connecting or disconnecting a circuit. The jumper is on when the jumper plug covers both wires of the terminal. Jumper settings can be changed by either attaching or removing the rectangular jumper plug. If the jumper is to be turned off, connect it to just one of the two terminal pins as shown in the figure below. By doing this, you can avoid losing the unused jumper plug.
Figure 2. lumpers
OFF (open) | ON (close) |
|
|
6