FCC COMPLIANCE STATEMENT

FOR AMERICAN USERS

This equpment has been tested end found to comply wth the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules, These limits art designed to provide reasonable protection against harmful interface in, a residential installation This equipment generates, uses, and can radiate radio frequency energy and, If not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guaranee that interference will not occur in a particular installation If this, equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment oft and on, the user is, encouraged to try to correct the interference by one or more of the following measure:

—Reorient or relocate the receiving antenna

—Increase the separation between the, equipment and receiver

—Connect, the equipment into, an outlet on, a, circuit different from that to which the receiver is connected

—Consult the dealer or an experienced radio/TV technician for help

This device complies with Part 15 of the FCC Rules Operation is subject to the following two conditions:

(I) this device may not cause harmful interference, and

(2)this device must accept any interference received, including interference that may cause undesired opreration

FOR CANADIAN USERS

This, digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus as set out in the radio interference regulation, of the Canadian Department of Communications.

Le présent appareil numérique n’émet pas de bruits radioelectriques dépassant les limites applicables aux appareils numériques de Class B prescrites dans le règlement sur le broullage radioélectriqus édicté par le Ministere des Communications du Canada.

WARNING

The connection, of a non-shielded equipment interface cable to this equipment will invalidate the FCC Certification of this, device and may cause interference levels which exceed the limits established by the FCC for this equipment It is the responsibility of the user to obtain and use a shielded equipment interface cable with this device If this equipment has more than one interface connector, do not leave cables connected to unused interfaces

Changes or modifications not expressly approved by Epson America, Inc , could void the user’s authority to operate the equipment

Seiko Epson Corporation shall not be liable against any damages or problems arising from the use of any options or any consumables products other than those designated as Original Epson Products or Epson Approved Products by Seiko Epson Corporation.